ARGOX X-3200 PPLB DRIVER DOWNLOAD

For the XVL, ignore this step. The other end of the parallel interface cable connects to the printer connector at the host computer. Check if the communication cable parallel or serial is connected securely to your parallel or serial port on the PC and to the connector on the printer at the other end. If the tension is too little at ribbon pickup, ribbon will not move smoothly, and needs control knob to rotate clockwise to increase tension. Do not operate the printer in an area where it might get wet. Pin assignments are as follows: To enable Cutter function, set by the LCD panel 30 Adjust Position of Label Sensor Function of the label sensor is to detect the gap, notch, or holes of labels, to help the printer for accurate print positions and label length.

Uploader: Kazigrel
Date Added: 1 February 2018
File Size: 5.57 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 47219
Price: Free* [*Free Regsitration Required]

If the ribbon is wrinkled at ribbon pickup, rotate counter-clockwise control knob of ribbon pickup, to decrease ribbon tension at ribbon pickup and further improve srgox wrinkle.

Argox x pplb drivers download

It decides which setting method – by command or by LCD panel, is prior. Key-in the product name and number.

W mm x H mm x D mm. Internal character sets standard 5 alpha-numeric fonts with height from 0. X series printers use ribbon wound ink-side in as default.

  GIGABYTE 7VAXP DRIVER DOWNLOAD

RS, parallel, and USB interfaces allow easy plug-and-play integration with your current system. Delete by application software for argpx no longer in use. Open the top cover to access the print head module 3.

Figure 3 3 Ribbon Supply Spindle 14 4. Then paper can be removed from the cutter as Figure 2. Pin 9 is reserved for a X–3200 keyboard device unit. The driver should now be installed. When using Ethernet model printer, please wait till the Ready Indicator to stop blinking, before starting printer operations.

FEED Press to show next parameter. When using a keyboard or barcode reader communicating with a host through argo Centronics or serial port is prohibited.

Argox X |

Place the printer within cable distance of the host and printer serial or parallel cable. Printer will enter Dump mode after printing configuration. It’s a community-based project which helps to repair anything. For technical and pin-out information, please refer to the Technical Reference in this manual.

ARGOX X-3200

If problem continues perform a label sensor calibration. Making a Keyboard Form 1.

Cleaning the Media Compartment Clean the media compartment with a cotton bud that has been moistened with a mild detergent. Be cautioned that this will reset all printer settings back to defaults; if possible, print the configuration label in advance before reset.

  CANON CAMERA POWERSHOT A590 DRIVER DOWNLOAD

Refer to ppb following command sample. Hold both buttons for about 3 seconds and release. Load new media to the printer. After driver installation is complete, click “Close”.

However as no port contention is made for this printer, if both PCs transmit data at the same time the data may become damaged in the receiving buffer. The sample steps below are based on ribbon wound ink-side in as an example.

Check whether you have received the following accessories together with the printer. The pin assignment of serial cable is different from PC. Please note, as shown in Fig. Rotate the control arbox clockwise to increase ribbon tension; rotate it counter-clockwise to reduce ribbon tension. The screens included for these steps are taken from Windows XP; steps in other versions of operation systems are similar.

The adjusting portions for two hex socket screw locks marked in Fig.